Griffin Nu form Case with EasyDock for iPhone 3G, 3G S
Dec 13, 2009 in
Accessories
- ¿ 2-piece shatter-proof polycarbonate shell snaps snug around your iPhone
- ¿ EasyDock closure allows quick charging & syncing
- ¿ Rigid screen protector guards your touchscreen, allows control of your iPhone
- ¿ Premium cleaning cloth included for proper care of your iPhone
Product Description
Nu Form gives hard-shell protection for your iPhone 3G in a slim, no-clip design. Impact-resistant polycarbonate shell snaps snug around your iPhone. Included screen protector is a hard, thin sheet that guards your touchscreen from smudges, scratches and fingerprints, but allows your fingers complete access to the touchscreen. EasyDock design makes Nu Form convenient to charge and sync: just slide open the case bottom and pop your iPhone into its dock…. More >>
Griffin Nu form Case with EasyDock for iPhone 3G, 3G S
Like this post? Subscribe to RSS feed!


5 comments
Victor Trac on December 13, 2009 at 9:54 pm
The included screen protector is more like a hard plastic that clings to the screen of the iPhone and leaves lots of ugly bubbles. I tried for a while to make it fit, but in the end just left it out.
The case itself is marketed as slimfit, but it’s actually a bit too think for me. After using it for a few weeks, I took it off the iPhone to clean it, and immediately noticed how much better my iphone felt naked. I think I’m not going to use this case anymore, as it defeats and ruins the iphone’s svelte design.
I suppose if you don’t mind the added bulk, it does its job of protecting the iphone.
George Sanchez on December 14, 2009 at 12:17 am
This case is great especially if you have a black IPHONE 3G. The color matches perfectly with black. I know the description says ‘Black’ but the only thing thats black on the case is the lower part of it. But again nice match to the IPhone 3G.
CR JUNK on December 14, 2009 at 1:57 am
I’ve had this case for a little over a month. Looks great and fits the iPhone perfectly, but has begun to crack in the top left corner. I have yet to drop the phone, so that does not explain the crack. Very disappointed. I’ve ordered a new case, the SwitchEasy Rebel, to replace this one.
E. Ossi on December 14, 2009 at 2:45 am
I purchased on these from amazon and it worked great…for about a two months. the problem is that the plastic is very thin around the volume controls and ringer on/off switch and snapped.
but i liked the case, and figured its cheap enough, so i bought another one. this one also worked great, until after a month IT broke.
i’d say don’t waste your money, buy a more durable case.
B. Goyanes on December 14, 2009 at 5:21 am
This case was perfect for my iphone, survived many drops. Be aware this case is half gray and half rubbrized black, and the grey area has some square mod design small on the back. Go for the Griffin Elan form faux leather if you want something really sharp looking for another millimeter of thickness, or go for the all rubberized version which looks classier than this one.
Definitely do not ever use any of those plastic shield covers that come with hardcases, crap and dust and dirt is always stuck underneath the plastic shield. Always get a self-adhesive one, like invisishield which is amazing, but save your receipt because they replace the shield free if it ever gets scratched. very nice!
yes, all well-fit hard cases will scratch your iphone (tiny thin scratches) if you do not carefully clean your iphone and remove any dirt or sand from the inside of the case before putting it on again! duh! That’s because they fit so well and protect your phone so well. So just keep it clean then.